Chipvac 200

The vacuum is developed by three single-phase by-pass motors, with independent switches, protected inside a solid steel head, which contains soundproofing material to reduce noise to a minimum during service. The control panel includes three independent switches and a vacuum indicator with warning light, useful for detecting filter saturation. Two handles on the head allow you to easily lift the filter for inspection or replacement.

Inside the steel filter chamber there is a polyester pocket filter cat. L, which protects the suction unit, ensures high dust retention and guarantees the purity of the outgoing air, thanks to a large surface area (14000 cm2) and high filtering efficiency (3 microns). The suction system with a Ø80mm inlet under the filter allows the simultaneous suction of dust, solids and liquids (within the capacity of the container) without having to replace or remove the filter.

The aspirated material is deposited in a large capacity tipping container. The use of a forklift simplifies emptying the vacuumed material directly into the waste containers. The 90° inclination of the CHIPVAC 200 bucket allows you to easily unload even the most difficult materials.

A perforated plate can be inserted to separate the chips, leaving them at the top of the bucket, while the liquids settle at the bottom of the container.

The tank is equipped with a 1 inch ball valve for emptying the aspirated liquids. A visual level indicator allows you to check the filling of the bucket during the vacuuming operation.