M70 PN

The industrial vacuum cleaner is equipped with a cast aluminum suction unit of the side channel blower type, in which the impeller is fixed directly to the motor shaft, and without transmission systems. This almost completely reduces the wear of the components and the consequent maintenance needs. These characteristics, together with the silence, make the engine particularly suitable for continuous service (even 24 hours a day), and allow it to develop a very high vacuum, higher than transmission systems of similar power.

The control panel of the industrial vacuum cleaner consists of a start-stop push-button panel, containing a thermal-magnetic switch. A vacuum gauge allows you to constantly check the level of depression and the saturation state of the filter, and to interrupt suction in the event of any anomalies. A double silencer reduces noise and reduces the impact of the outgoing air.

Cat. “L” polyester filter with filtration efficiency up to 3 microns.

It is not necessary to remove the motor head and the filter from the vacuum cleaner to empty the collection container, mounted with an intelligent lever system that allows it to be quickly released.

The manual cleaning system with vertical filter shaker lever allows the operator to clean the filter effortlessly and at any time. By doing so, the life of the filter itself is extended, preventing its saturation and maintaining the chip extractor’s suction performance constant. The front suction system with a cast aluminum mouthpiece with Ø80 positioned below the filter allows you to simultaneously suck up dust, solids and liquids (within the capacity of the container) without the need to replace or remove the filter.

A quick-release container, made of resistant steel mounted on wheels (100 liter capacity), allows you to dispose of shavings, scraps and vacuumed dust quickly and without getting dirty, with the possibility of bagging.